Enermax

Technical Specifications	24V, 10A	12V, 10A	12V, 6A
Electrical Characteristics
Input Voltage	170 – 300V AC	170 – 300V AC	150 – 300V AC
Output Voltage-Boost mode	27.4 – 28V DC	14V DC	14V DC
Output Voltage-Float mode	26.2 V DC	13.4V DC	13.4V DC
Charging Current-Boost mode	10A	10A	60A
Charging Current-Float mode	0 – 4A	0 – 4A	0 – 2.5A
Leakage Current @ 230 V ac	< 2mA	< 2mA	< 2mA
Line regulation	< 1%	< 1%	< 1%
Load regulation	< 1%	< 1%	< 1%
Ripple content	150mV p-p	150mV p-p	150mV p-p
Dielectric strength:
1. Between Input & Output	2Kv AC	2Kv AC	2Kv AC
2. Between Input & eARTH	1.5Kv AC	1.5Kv AC	1.5Kv AC
3. Between Input & eARTH	1.5Kv AC	1.5Kv AC	1.5Kv AC
Protections
In rush current	Limited by NTC Thermistor
Over voltage at Input	Shut down above 300V AC
Under voltage at Input	Cutoff at 140V AC. Cut in at 160V AC
Over voltage at Output	29.5V		15.5V
Short circuit at Output	Protected		Protected
Overload at Output	Protected		Protected
Reverse polarity of Battery	Protected		Protected
Over voltage due to external source	Protected		Protected
Other Features
Indications	Mains ON, Boost mode, Float mode, Battery Reverse
Annunciation	Potential free NO/NC contact for Charger ON/FAIL
Mechanical
Type of mounting	Wall mounting Type
Dimensions LxWxH	195x127x94	185x125x65	175x115x60
Weight (Approx.)	1500g	1200g	1000g
Environmental
Operating Temperature	0 – 50 Deg.C
Operating Relative Humidity	0 – 80% Max.
Vibrations	10 – 500Hz 2G-10min. / 1 Cycle 60 min. along all three axes

Battery Chargers(For Diesel Generator)